Internally Installed
Shade/Heat Retention
Request Form

USGR is a worldwide supplier of nets, shades and fabrics from warehouses worldwide. Minimums apply.

Please complete as much of the following as you can. We understand not all information may be readily available. We will contact you for additional information if needed to assist you in developing your project. For external systems, use submit form.
1. CONTACT INFORMATION
1.1 Name:
1.2 E-mail Address:
1.3 Company Name:
1.4 Company Address:
1.5 Telephone Number:
1.6 Fax Number:

2.		 JOB INFORMATION (SET 1)
2.1 Greenhouse manufacturer
2.2 Greenhouse model
2.3 House Width feet inches
2.4 House Length feet inches
2.5 Truss or Bay Spacing feet inches
2.6 How Many Houses
2.6 Gutter Connected: Yes
No

3.		 SHADE SYSTEM
3.1 Type of Shade System: Truss-to-Truss Push Pull Drive
Slope-Flat-Slope Profile
Truss-to-Truss Push Pull Drive
Flat Profile
Truss-to-Truss Push Pull Drive
Slope-Slope Profile (Gutter to Peak)
Gutter to Gutter Chain and Cable Drive Flat Profile
Other

4.		 TYPE OF LUDVIG
4.1
Shade Factor Ludvig
Standard		 Svensson
Revolux		 Bonar
Phormium
40% to 50% ULS-14 R PH44
50% to 55% ULS-15 R PH55
60% to 65% ULS-16 R PH66
70% to 75% ULS-17 R PH77
80% to 85% ULS-18 R
Blackout - 99.9% LS-100

Blackout - 99.9% Obscura A&B

Blackout - 99.9% Rollups Novathene

Other Type of Material Other

5.		 EQUIPMENT ABOVE BOTTOM CHORD OF TRUSS
5.1 Select those that apply Roof Ridge Vents
JetFans/Tubes
Unit Heaters
Horizontal Air Flow Fans
Other

7.		 ADDITIONAL COMMENTS
7.1 Add your comments:
If your project is new construction, then endwall, sidewall, truss, etc. information may be necessary if USGR is not already familiar with the manufacturer's specifications.

IMPORTANT: the voltage requirements of your site are very important.

Copyright © 1998-2008 U.S. Global Resources (USGR). All rights reserved.
Web site developed by Infothai CM Co., Ltd.
This page was updated on:  February 11, 2008